OPERATION DETAILED CONTROLS AND GAUGES
3-31
EMERGENCY EXIT FROM OPERATOR'S CAB 3
q If for some reason, the cab door does not open, remove
the rear window and use it as an emergency escape.
q Remove the rear window as follows.
1. Pull ring (1) and completely remove seal (2) from the rub-
ber core.
2. When the corner of the front window glass is pushed strongly, it can be removed to the outside.
q Do not remove the rear window except when using it as an emergency exit.
DOOR LOCK 3
WARNING
q Before the releasing the door lock, always stop the machine on flat ground.
q Never release the door lock on a slope. The door may suddenly close and cause injury.
q When releasing the door lock, do not extend your body or hands outside the machine and do not put
your hands on the door frame. The door may suddenly close and cause injury.
Use the door lock to fix the door in position after opening it.
1. Push the door against catch (1) to lock it in position.
2. When closing the door, push down the lever(2) on the left
of the operator's seat to release the catch.
3. When attaching the door in position, lock it firmly to the
catch.
To Next Page
Loading...
Need help?
General
