Komatsu PC130-7 User Manual

MAINTENANCE MAINTENANCE PROCEDURE
4-39
WASH WASHABLE FLOOR 4
WARNING
q When setting the machine at an angle, use strong blocks to stabilize the machine and be extremely
careful when carrying out the operation.
q If the control levers are touched by mistake, the work equipment or machine may suddenly move, and
this may lead to a serious accident. Always set the safety lock lever securely to the LOCK position
before standing up from the operator's seat.
q When setting the machine at an angle, use strong blocks to stabilize the machine and be extremely
careful when carrying out the operation.
q If the control levers are touched by mistake, the work equipment or machine may suddenly move, and
this may lead to a serious accident. Always set the safety lock lever securely to the LOCK position
before standing up from the operator's seat.
NOTICE
q When carrying out this operation, be careful not to get water on the monitor and connectors inside the
operator's cab.
q Never spray water above the pedestal of the operator's seat (2).
q If any water splashes on the surrounding equipment, be sure to wipe it off.
With the washable floor, it is possible to flush out the dirt on the cab floor directly with water.
Washing Washable Floor Mat
1. Stop the machine on horizontal ground, lower the bucket to the ground, and then stop the engine.
2. When washing the floor mat, use a brush to remove the dust, or direct the water onto the mat and wash it with
a brush.

Komatsu PC130-7 Specifications

General

Brand	Komatsu
Model	PC130-7
Category	Excavators
Language	English