381lUBRICATION
SYSTEM
184
- Start the engine and let it run idle for
30
seconds.
- Stop the engine and check that it is oil-tight.
- Stand the motorcycle upright
on
a horizontal surface.
-
Remove
the
screw
connection
on
the
alternator
cover.
- Fill in engine oil
to
the upper half of level viewer
•.
Engine oil (total
0.60
I <0.63 qt.) Engine oil
(SAE
lOW/50) (
or
p.
250)
filling
capacity
approx.)
- Mount and tighten the screw connection
on
the alternator cover.
•
Info
I
Too
little
engine oil or poor-quality engine oil results in premature wear
to
the engine.
-
Remove
the screw
cap.
on
the alternator cover and
fill
up with engine oil.
I Engine oil (SAE lOW/50) (or
p.
250)
- Mount and tighten screw cap
•.
...
Danller
W
Danler
of
poisoninl
Exhaust
gases
are
poisonous and inhaling them may
result in unconsciousness and/or death.
- When running the engine, always make sure there is sufficient ventila-
tion, and
do
not start or run the engine in
an
enclosed space without
an
effective exhaust extraction system.
- Start the engine and check that
it
is oil-tight.
- Check the engine oil level.
(
or
p.
181)
- Check the engine oil level. (
or
p.
181)
-
Remove
the chain adjuster release screw.
- Mount and tighten special tool
O.
Guideline
I Oil pressure adapter
I
MlOxl
110
Nm
(7.4
Ibf
It)
I
I Oil pressure adapter
(77329006000)
(or
p.
259)
- Connect pressure
gauge.
without the t-plate
to
the special tool.
I Pressure testing tool
(61029094000)
(or
p.
257)
...
Danger
W
Danger
of
poisoning
Exhaust
gases
are
poisonous and inhaling them may
result in unconsciousness and/or death.
- When running the engine, always make sure there is sufficient ventila-
tion, and
do
not start or run the engine in
an
enclosed space without
an
effective exhaust extraction system.
- Start the engine and let it warm up.
- Check the engine oil pressure.
Engine oil pressure
Engine oil temperature:
80°C
0.9
bar
(13
psi)
(176
OF)
Engine speed:
1,600
rpm
Engine oil temperature:
80
°C
2.5
bar
(36
psi)
(176
OF)
Engine speed:
6,000
rpm
381lUBRICATION
SYSTEM
184
- Start the engine and let it run idle for
30
seconds.
- Stop the engine and check that it is oil-tight.
- Stand the motorcycle upright
on
a horizontal surface.
-
Remove
the
screw
connection
on
the
alternator
cover.
- Fill in engine oil
to
the upper half of level viewer
•.
Engine oil (total
0.60
I <0.63 qt.) Engine oil
(SAE
lOW/50) (
or
p.
250)
filling
capacity
approx.)
- Mount and tighten the screw connection
on
the alternator cover.
•
Info
I
Too
little
engine oil or poor-quality engine oil results in premature wear
to
the engine.
-
Remove
the screw
cap.
on
the alternator cover and
fill
up with engine oil.
I Engine oil (SAE lOW/50) (or
p.
250)
- Mount and tighten screw cap
•.
...
Danller
W
Danler
of
poisoninl
Exhaust
gases
are
poisonous and inhaling them may
result in unconsciousness and/or death.
- When running the engine, always make sure there is sufficient ventila-
tion, and
do
not start or run the engine in
an
enclosed space without
an
effective exhaust extraction system.
- Start the engine and check that
it
is oil-tight.
- Check the engine oil level.
(
or
p.
181)
- Check the engine oil level. (
or
p.
181)
-
Remove
the chain adjuster release screw.
- Mount and tighten special tool
O.
Guideline
I Oil pressure adapter
I
MlOxl
110
Nm
(7.4
Ibf
It)
I
I Oil pressure adapter
(77329006000)
(or
p.
259)
- Connect pressure
gauge.
without the t-plate
to
the special tool.
I Pressure testing tool
(61029094000)
(or
p.
257)
...
Danger
W
Danger
of
poisoning
Exhaust
gases
are
poisonous and inhaling them may
result in unconsciousness and/or death.
- When running the engine, always make sure there is sufficient ventila-
tion, and
do
not start or run the engine in
an
enclosed space without
an
effective exhaust extraction system.
- Start the engine and let it warm up.
- Check the engine oil pressure.
Engine oil pressure
Engine oil temperature:
80°C
0.9
bar
(13
psi)
(176
OF)
Engine speed:
1,600
rpm
Engine oil temperature:
80
°C
2.5
bar
(36
psi)
(176
OF)
Engine speed:
6,000
rpm
To Next Page
Loading...
Need help?
General
