KTM 400 EXC AUS 2011 User Manual

O8IMASK, FENDER 69
- Remove screws •. Remove the front fender.
- Make sure the spacers remain in place.
- Ensure that the spacers are mounted in the fender.
- Position the front fender. Mount and tighten screws
•.
Guideline
I Remaining screws, chassis
110 Nm (7.4 Ibf It) I
• Info
I Make sure the holding lugs engage in the start number plate or headlight
mask.
- Switch off all electrical equipment.
-
Remove screw. and take off clamp.
-
Loosen the rubber band •. Push up the headlight mask and swing it forwards.
- Pull out the electric plug
connector. and remove the headlight mask with the
headlight.
- Connect the electric plug connector
••
O8IMASK, FENDER 69
- Remove screws •. Remove the front fender.
- Make sure the spacers remain in place.
- Ensure that the spacers are mounted in the fender.
- Position the front fender. Mount and tighten screws
•.
Guideline
I Remaining screws, chassis
110 Nm (7.4 Ibf It) I
• Info
I Make sure the holding lugs engage in the start number plate or headlight
mask.
- Switch off all electrical equipment.
-
Remove screw. and take off clamp.
-
Loosen the rubber band •. Push up the headlight mask and swing it forwards.
- Pull out the electric plug
connector. and remove the headlight mask with the
headlight.
- Connect the electric plug connector
••

KTM 400 EXC AUS 2011 Specifications

General

Brand	KTM
Model	400 EXC AUS 2011
Category	Motorcycle
Language	English