Ol/FORK,
TRIPLE
CLAMP
32
Installinllhe
lower
triple
clamp
(EXC
EIUAUS)
~
• I
Illill]iljj
,-
8-
@
.
~
~.
~
••
@
- Clean the bearing and sealing elements, check for damage, and grease.
1 High viscosity grease (r
p.
252)
- Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
- Check whether the top steering
head
seal.
is correctly positioned .
-
Push
on
protective ring
e.
- Position the upper triple clamp with the steering.
- Mount
screw.
but
do
not tighten yet.
- Position the clutch line, wiring harness, and
COl
control unit. Mount and tighten
screws
•.
Guideline
1 Remaining screws, chassis
- Position the fork legs.
•
Info
110
Nm
(7.4
Ibf
ft) 1
I The topmost milled groove in the fork leg must
be
flush with the top
edge
of
the upper triple clamp.
Position bleeder
screws.
toward the front.
- Fully tighten screws
•.
Guideline
Screw, bottom triple clamp
M8
- Tighten screw
•.
Guideline
1 Screw, top steering
head
1 M20x1.5
15
Nm
(ll.llbfft)
110
Nm
(7.4
Ibf
It)
1
Ol/FORK,
TRIPLE
CLAMP
32
Installinllhe
lower
triple
clamp
(EXC
EIUAUS)
~
• I
Illill]iljj
,-
8-
@
.
~
~.
~
••
@
- Clean the bearing and sealing elements, check for damage, and grease.
1 High viscosity grease (r
p.
252)
- Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
- Check whether the top steering
head
seal.
is correctly positioned .
-
Push
on
protective ring
e.
- Position the upper triple clamp with the steering.
- Mount
screw.
but
do
not tighten yet.
- Position the clutch line, wiring harness, and
COl
control unit. Mount and tighten
screws
•.
Guideline
1 Remaining screws, chassis
- Position the fork legs.
•
Info
110
Nm
(7.4
Ibf
ft) 1
I The topmost milled groove in the fork leg must
be
flush with the top
edge
of
the upper triple clamp.
Position bleeder
screws.
toward the front.
- Fully tighten screws
•.
Guideline
Screw, bottom triple clamp
M8
- Tighten screw
•.
Guideline
1 Screw, top steering
head
1 M20x1.5
15
Nm
(ll.llbfft)
110
Nm
(7.4
Ibf
It)
1