14Service Manual – SC5000 03 - General Information
Fastener Torque Specications
Standard Torque
Specications (unless
otherwise specied)
Size Plated Steel Stainless Steel
#10 42 in.-lb. 28 in.-lb.
1/4“ 100 in.-lb. 67 in.-lb.
5/16” 17 ft.-lb. 11 ft.-lb.
3/8” 31 ft.-lb. 20 ft.-lb.
1/2” 75 ft.-lb. 50 ft.-lb.
3/4” 270 ft.-lb. 180 ft.-lb.
M5 61 in.-lb. 36 in.-lb.
M6 9 ft.-lb. 62 in.-lb.
M8 22 ft.-lb. 13 ft.-lb.
M10 44 ft.-lb. 25 ft.-lb.
M12 70 ft.-lb. 40 ft.-lb.
Maintenance Schedule
Maintenance intervals given are for average operating conditions. Machines used in severe operational
environments may require service more often.
Maintenance Item
Interval
Daily Weekly Monthly Yearly
Charge Batteries
•
Check/Clean Tanks & Hoses
•
Check/Clean/Rotate the Brushes/Pads
•
Check/Clean the Squeegee
•
Empty/Clean Debris Catch Tray in Recovery Tank
•
Check/Clean the vacuum motor foam lter
•
Clean Hopper on Cylindrical System
•
Clean the surface of the magnetic smartkey reader •
Check Battery Cell Water Level (does not apply to gel cell batteries) •
Inspect Scrub Housing Skirts
•
Inspect and clean Solution Filter
•
Clean Solution Trough on Cylindrical System
•
Purge Detergent System (if present) •
* Clean the solution tank •
Lubricate the Machine •
Check Vacuum Motor Carbon Brushes (replace motor at 2000 hrs) 1200 Hrs
Check Brush Motor Carbon Brushes 1200 Hrs
* Cleaning the solution tank is only needed if you use a mixture of water and detergent within the tank.
Note: See the individual machine system sections for maintenance information.
To Next Page
Loading...
Need help?
General
