EasyManuals Logo
Home>Nilfisk-Advance>Scrubber>Advance SC5000

Nilfisk-Advance Advance SC5000 Service Manual

Nilfisk-Advance Advance SC5000
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #217 background imageLoading...
Page #217 background image
217Service Manual – SC5000 90 - Options and Accessories
Scrub-N-Vac
Wash Hose
MMC Setup
Conguration
Description The Wash Hose and Scrub-N-Vac are similar options, in that they both make use
of the option pump. For this reason, only one of these options may be present on
a machine at a time. The wash hose is a handheld spray hose for off-machine
cleaning. Scrub-N-Vac is a remote cleaning wand with water spray and vacuum
suction, to facilitate oor cleaning to areas not easily reached by the main machine.
Either option consists of an on-demand solution pump located on the rear chassis
below the solution tank, which operates when a drop in pressure is detected in
the solution hose leading to the wand. The inlet to the option pump connects to
the main solution line of the machine upstream from the solution solenoid, so that
water is available without the scrub system being active. The Scrub-N-Vac wand
and hose includes a water supply line and vacuum suction line.
Service Impact Low; troubleshooting
Reference The option pump is covered in “30 - Solution System” on page 167.
TrackClean
MMC Setup
Conguration
Description The TrackClean module provides machine operational and management
information to the machine’s owner from remote connectivity. From a remote
website, the machine’s owner is able to determine the machine’s location, who is
operating the machine, and various operational and performance parameters.
The TrackClean module is located inside the steering column and connects to an
existing electrical connector. It uses the CAN Bus to communicate with the Main
Machine Controller. The module includes an internal battery to provide operational
power, even if the machine is not operational.
Service Impact Low; troubleshooting
Dual Vacuum
MMC Setup
Conguration
Description Adds a second vacuum motor (Vac 2) to the recovery tank.
Service Impact Low; Same procedures as for single vacuum
Side Sweep
MMC Setup
Conguration
Description Available only for 32” cylindrical models. Adds a side broom to the right-front of the
deck area. The option also includes a proximity sensor to detect when the operator
has manually raised the side broom out of operating position.
Service Impact Low; Broom pressure adjustment, troubleshooting

Table of Contents

Other manuals for Nilfisk-Advance Advance SC5000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance Advance SC5000 and is the answer not in the manual?

Nilfisk-Advance Advance SC5000 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelAdvance SC5000
CategoryScrubber
LanguageEnglish

Related product manuals