212Service Manual – SC5000 40 - Recovery System
Removal and Installation
Recovery Tank
Removing the recovery tank is a prerequisite to
performing other procedures on the machine, ro
gain access to components otherwise not easily
accessible.
1. Drain the recovery tank.
2. Raise the operator’s seat and disconnect the
vacuum motor electrical connector.
3. Disconnect the recovery hose from the
squeegee mechanism.
4. Using either an overhead hoist, or at least
2 people, lift the recovery tank upward to
remove it from the pins (A) on the top of the
solution tank.
Vacuum Motor
This procedure may be completed with the recovery tank installed on the machine. However, removing the
tank will make the procedure easier, as you won’t need to work on the components from inside the battery
bay. Refer to the procedure above for removing the tank.
1. Remove the 5 screws (B) and
4 washers (C) that secure the
vacuum plate (A), and remove
the plate. Note: The screw
securing the cable retainer (D)
does not use a washer.
A
A
B
C
D
To Next Page
Loading...
Need help?
General
