2 Instruction Descriptions
2-128
NJ-series Instructions Reference Manual (W502)
• If this instruction is in a master control region and the master control region is reset, the operation is
as follows:
• The timer stops. The values of ET and Q at that time are retained.
• When the master control reset is cleared, ET is incremented again from the value that was
retained.
• If an Out instruction is connected to Q, the execution condition to the Out instruction is FALSE
even if the value of Q is TRUE.
• Reset is enabled.
• If this instruction is not executed due to the execution of a jump instruction (e.g., the JMP instruction),
the value of ET is not updated. However, timing still continues. Therefore, ET is updated to the correct
value the next time the instruction is executed.
• If this instruction is used in a ladder diagram, the value of Q changes to FALSE if an error occurs in
the previous instruction on the rung.
To Next Page
Loading...
Need help?
General
