Omron Q2A Series Technical Manual

Startup Procedure and Test Run
4
4.5 Keypad Operation
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual 141
1. Push ( ) to show the HOME screen.
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on , push ( ) to show [ ] on .
2. Push ( ).
3. Push or to select [Wizard & Autotuning], then push .
4. Push or to select [Q2 Wizard], then push .
5. Push or to select [Yes], then push .
This operation will initialize all parameters.
6. Push or to select the item to set, then push .
7. For the next steps, follow the instructions shown on the keypad until the “Parameter Change Confirmation
Screen” is shown.
8. In the parameter change confirmation screen, push or to examine the changed parameter, then
select [Apply each parameter] at the bottom of the screen and push .
Note:
To change a parameter, push or to select the parameter to change, then push to show the parameter setting
screen.
9. Push or to select [Yes], then push to apply the parameter settings.
The Q2 Wizard procedure is complete.
◆ Start Data Logging
The data log function keeps a record of a maximum of 10 drive monitors. The procedure in this section shows
how to start logging data.
1. Make sure that a microSD card is inserted in the keypad.
2. Push ( ) to show the HOME screen.
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on , push ( ) to show [ ] on .
3. Push ( ).
4. Push or to select [Monitor & Diagnostics], then push .
5. Push or to select [Data Logger], then push .
6. Push or to select [Yes] or [No], then push .
• [Yes]: Data logging starts.
• [No]: Data logging will not start.
If the drive was logging data when you entered the command, the drive will ask to stop data logging.
◆ Set Data to Log
■ Set Monitor to Log
The procedure in this section shows how to set the monitor for which to log data.
1. Push ( ) to show the HOME screen.
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on , push ( ) to show [ ] on .
2. Push ( ).

Omron Q2A Series Specifications

General

Brand	Omron
Model	Q2A Series
Category	Controller
Language	English