Chapter 5: Advanced Reporting
Using Advanced Reporting Reports
124 Quantum Scalar i40 and Scalar i80 User’s Guide
4 Click Save.
The report appears in the drop-down list next to the Load button.
Using a Saved Template
To use a saved template, select the template from the drop-down list
and click
Load.
Deleting a Template
To delete a template, select the template from the drop-down list and
click
Delete.
Loading and Reloading
Advanced Reporting
Data
When you first open an Advanced Report configuration screen, the
system loads all the data from the library log file for that report to the
Internet browser in preparation for creating your reports. If there is a lot
of information in the log files, this may take several minutes.
The data that is loaded in the Internet browser remains unchanged until
you log out of your library session or reload the data. If new data is
added to the library log file during your session (for example, a
TapeAlert occurs), it will not appear in the on-screen report until you
either log out of the library and log on again, or reload the data.
To reload the data without logging out, click the Reload button on the
report’s configuration page. This action reloads the entire data for that
report, which may again take several minutes.
You can see how many records were loaded from the log files for this
report by looking at the Report Data section of the Report Configuration
page. A note says “XX records read,” where XX is the number of records
(see
Figure 20 on page 125).
7 Lists the number of records currently loaded in the Internet browser for this report.
8 Deletes all the Advanced Reporting data.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
