Chapter 9: Installing, Removing, and Replacing Components
Removing and Replacing the System Control Board
Quantum Scalar i40 and Scalar i80 User’s Guide 283
10 Click OK, then click OK again to agree to restart the library.
The Web client displays the following message:
Decoding installation bundle...done.
Validating bundle...good.
Installing firmware...library will reboot when complete.
11 Go to the operator panel and wait until the Setup Wizard displays
on the screen. The Setup Wizard screen may take up to 20 minutes
to appear.
12 Continue as follows:
• If you have saved a library configuration that you want to
restore on the library, go to:
Restoring the Library Configuration
on page 283.
• If you do NOT have a saved library configuration to restore on
the library, go to:
Manually Reconfiguring the Library on
page 284.
Restoring the Library
Configuration
Follow the instructions in this section if you have a saved library
configuration that you want to reinstall on the library.
1 On the operator panel, press Cancel to exit the Setup Wizard.
2 Take note of the library’s IP address (on the operator panel, select
Reports > Network Settings).
3 Access the Web client using the IP address and log in using the
default user name and password:
• User name: admin
• Password: password
Note: Once you restore the configuration, all your former user
names and passwords are restored.
4 Restore the configuration using the Web client as follows:
a Select Tools > Save/Restore Configuration.
b Select Restore System Configuration.
c Click Browse. Navigate to the saved configuration and click
Open.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
