Chapter 4: Configuring the Library
Configuring SNMP Settings
44 Quantum Scalar i40 and Scalar i80 User’s Guide
Operator Panel
1 Select Setup > Network Configuration.
2 Modify the fields using the method described in Navigating and
Editing on the Operator Panel on page 27.
Web Client
Select Setup > Network Management > Network.
Configuring SNMP Settings
Simple Network Management Protocol (SNMP) is a light-weight
protocol designed for remote management and monitoring of
infrastructure devices. The library provides SNMP support, so an external
management application can be configured to receive library SNMP
information. The library supports SNMP by publishing a Management
Information Base (MIB) that can be queried to obtain the status of the
library and many of its individual components. SNMP information can
be obtained from the library using SNMP Traps and GET queries.
For more information about SNMP, see the
Scalar i40 and Scalar i80
Basic SNMP Reference Guide
(6-66773-xx).
For information on integrating MIBs with an SNMP management
application, contact your network management application vendor.
Registering External
Management
Applications
Administrators can register transport protocols, IP addresses, and port
numbers of external management applications to enable them to
receive SNMP traps from the library. (By default, the library ignores all
SNMP SET operations, so external management applications cannot
register themselves to receive SNMP traps from the library.)
After registering the transport protocols, IP addresses, and
corresponding port numbers, you can perform a test to verify that the
library can send the SNMP traps to the addresses.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
