Quantum Scalar i40 User Manual

Chapter 4: Configuring the Library
Default Configuration
40 Quantum Scalar i40 and Scalar i80 User’s Guide
Default Configuration
The library comes with a default configuration, which you can modify at
any time. The default configuration is as follows:
Feature Default Configuration
Library host name library
Network settings IPv4, DHCP enabled
IPv6 disabled
Number of partitions Equal to the number of unique tape
d
rives — based on interface type (Fibre
Channel or SAS) and drive generation
(LTO-4, LTO-5) — not currently
assigned to a partition.
Storage slots are divided equally
amo
ng the partitions.
Number of I/E station slots 5
Number of cleaning slots 0
Configuring Network Settings
The operator panel Setup Wizard allows you to configure network
settings that allow remote access to the library from the Web client. At a
minimum, you must initially configure the network IP address from the
operator panel. After the initial configuration, you can modify the
network settings from either the operator panel or the Web client.

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g