Quantum Scalar i40 User Manual

Chapter 6: Performing Library Operations
Performing Media Operations
Quantum Scalar i40 and Scalar i80 User’s Guide 151
• On the Scalar i40 and the bottom right magazine of the Scalar
i80, reach under the open magazine and insert the tool directly
into the access hole in the library chassis to depress the release
latch, while pulling outward on the magazine bezel handle.
• On the top right magazine of the Scalar i80, reach under the
open magazine and press the release latch directly with your
finger, while pulling outward on the magazine bezel handle.
Figure 30 Magazine Release
Latch Access
Magazine release latch access holes
Performing Media Operations
This section describes how to import, export, load, unload, and move
data cartridges in the library. The following section,
Cleaning Tape Drives
on page 163, describes how to perform similar operations with cleaning
cartridges.
Note: The information and procedures in this user’s guide apply
specifically to the library Web client and the operator panel
user interface, not to the host application. Performing media
operations through the library user interface may affect your
host application. See your host application documentation for
information.

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g