Quantum Scalar i40 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Removing and Replacing the Front Bezel
Quantum Scalar i40 and Scalar i80 User’s Guide 255
5 Make sure all the magazines are pulled out a few inches (or
removed) to allow you to remove and install the bezel without
damaging it.
6 Remove and set aside the two screws securing the bezel to the
bottom of the chassis (see Figure
57 on page 255).
7 Remove and
set aside the two screws securing the bezel to the top
of the chassis (see Figure
58 on page 256).
Figure 57 Bezel Screw
Locations on Bottom of Library
Bottom
bezel
screws

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g