Quantum Scalar i40 User Manual

Chapter 8: Getting Information About the Library
Viewing Library Information on the Operator Panel
222 Quantum Scalar i40 and Scalar i80 User’s Guide
• Number of I/E station slots containing a tape cartridge assigned to
the partition
Operator Panel
1 Select Reports > Partitions.
2 If the library contains more than one partition, use the Up and
Down buttons to select a partition and press Select.
Viewing Tape Drive
Information
The operator panel provides an overview of tape drive information. For
each installed tape drive, you can see the following information:
• Online/offline mode
• Partition to which the tape drive is assigned
• Whether the tape drive is the control path for the partition
• State (ready/active/mounted)
• WWNN (if Fibre Channel) or SAS address (if SAS)
Operator Panel
1 Select Reports > Tape Drives.
2 If the library contains more than one tape drive, use the Up and
Down buttons to select a tape drive and press Select.
Viewing Network
Settings
A short report on the operator panel displays the library’s network
settings: host name, IP address, and network configuration.
Operator Panel
1 Select Reports > Network Settings.
2 If IPv6 is enabled, the IPv4 information is shown on the first screen.
Press Next to see the IPv6 address information on the next two or
more screens. Although the library can have unlimited IPv6 address,
a maximum of three are shown in this report.

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g