Quantum Scalar i40 User Manual

Chapter 7: Encryption Key Management
Scalar Key Manager Functions Available on the Library
194 Quantum Scalar i40 and Scalar i80 User’s Guide
3 Select an SKM partition configured for library managed encryption,
and temporarily disable library managed encryption by changing
the Encryption Method from Enable Library Managed to Allow
Application Managed (see
Figure 36 on page 194). Remember
which partition it is
, because you will be changing it back in a few
minutes.
4 Click Apply.
Caution: When you change the partition’s encryption method to
Allow Application Managed, the data that was
written to the tapes while the partition was configured
for Enable Library Managed
can no longer be read,
until you change the partition back to Enable Library
Managed. You will only be disabling for a short time,
and then changing back to Enable Library Managed
(just to trigger the key generation process) so this
should have little effect, unless you forget to turn it
back to Enable Library Managed.
Figure 36 Changing
Encryption Method to Allow
Application Managed
5 Wait 3 minutes to allow the changes to complete.
6 Go back
to the encryption partition configuration screen and
change the Encryption Method back to Enable Library Managed
(see Figure
37).
7 Click Apply.

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g