Quantum Scalar i40 User Manual

Chapter 8: Getting Information About the Library
Viewing the Library Configuration Report
Quantum Scalar i40 and Scalar i80 User’s Guide 211
•Click Show Barcodes to display the barcodes for all imported
cartridges.
• By default, the Library Configuration Report displays the
coordinate
s for all licensed slots that are assigned to a partition.
To view all library slot coordinates, click Show ALL coordinates.
• To print the report, click the Print icon in
the upper right of the
screen.
Clicking on a resource (tape drive, slot,
partition, or chassis) brings up a
detailed window containing the following information:
• T
ape Drives — The following information is provided for each
installed tape drive:
• Fi
bre Channel tape drive — interface type, tape drive type,
state (ready/not ready), status (online/offline), assigned partition
name, location coordinates, media barcode (if media is in slot;
“No_Label” means unreadable barcode), media type (if media is
in the slot), element address, vendor, model, form factor (half
height or full height), physical SN, logical SN, world wide node
name (WWNN), world wide port name (WWPN), loop ID,
requested topology, requested speed, actual topology, actual
speed, maximum speed, tape drive firmware level, whether the
tape drive is the control path for its partition, and encryption
method.
• Serial Attached
SCSI (SAS) tape drive — interface type, tape
drive type, state (ready/not ready), mode (online/offline),
assigned partition name, location coordinates, media barcode
(if media is in slot; “No_Label” means unreadable barcode),
media type (if media is in slot), element address, vendor, model,
form factor (half height or full height), physical SN, logical SN,
SAS Address, tape drive firmware level, whether the tape drive is
the control path for its partition, and encryption method.
• Slots — The
following information is provided for each slot: type,
assigned partition name (storage and I/E station slots only), location
coordinates, cartridge barcode (storage and I/E station slots only;
“No_Label” means unreadable barcode), media type, element
address, encryption method, get count, get retries, put count, and
put retries. If the slot is a cleaning slot, the cleaning status (usable/
expired) and cleaning count (the number of times the cartridge was
used to clean a tape drive) are also displayed.

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g