"authfree" Command
When [Simple (Limitation)] is selected under printer job authentication, the telnet authfree command
makes it possible to specify objects to be excluded from printer job authentication.
The default user name for logging in to telnet is "admin". No password is configured. For details on how
to login to and use telnet, see "Using telnet", Connecting the Machine/ System Settings.
View settings
msh> authfree
If print job authentication exclusion is not specified, authentication exclusion control is not
displayed.
IPv4 address settings
msh> authfree "ID" range_addr1 range_addr2
IPv6 address settings
msh> authfree "ID" range6_addr1 range6_addr2
IPv6 address mask settings
msh> authfree "ID" mask6_addr1 masklen
Parallel/USB settings
msh> authfree [parallel|usb] [on|off]
• To exclude parallel and USB connections from printer job authentication, set this to "on". The
default setting is "off".
• Always specify either "parallel" or "USB".
"parallel" can be specified when an optional IEEE 1284 interface board is installed.
Authentication exclusion control initialization
msh> authfree flush
• In both IPv4 and IPv6 environments, up to five access ranges can be registered and selected.
2. Configuring User Authentication
66
To Next Page
Loading...
Need help?
General
