1. UNIX Configuration
This section explains how to set up a network printer and check print status using UNIX
Before Setup
• To print from a UNIX workstation, use a file that the printer supports.
• Setup varies depending on the print command. Make sure to configure settings accordingly.
Using the lp/lpr Commands
1. Use the installation shell script to register the device option, as well as the printer host
name and the IP address.
For details, see p.8 "Using the Installation Shell Script".
2. Start printing.
For details, see p.17 "Printing Method".
Using the rsh/rcp/ftp Commands
1. Edit the host file to register the printer host name and the IP address.
For details, see p.12 "After Executing the Installation Shell Script".
2. Start printing.
For details, see p.17 "Printing Method".
• If you cannot edit the host file, use the install shell script to register the host name.
7
To Next Page
Loading...
Need help?
General
