Encrypting Data on the Hard Disk
• Keep SD cards out of reach of children. If a child accidentally swallows an SD card, consult a
doctor immediately.
Prevent information leakage by encrypting the Address Book, authentication information, and stored
documents as the data is written.
When the data encryption settings are enabled, an encryption key is generated and this is used to
restore the data. This key can be changed at any time.
Data that is encrypted
This function encrypts data that is stored in the machine's NVRAM (memory that remains even after
the machine has been turned off) and on the hard disk.
The following data is encrypted:
• Address Book data
•
User authentication information
• Data stored in Document Server
• Temporary stored documents
• Logs
• Network I/F setting information
• System settings information
• If the machine malfunctions or needs to be replaced, the existing data can be transferred to a new
machine, even if the data is encrypted. To transfer data, contact your service representative.
Time required for encryption
When setting up encryption, specify whether to start encryption after deleting data (initialize) or
encrypt existing data and retain it. If data is retained, it may take some time to encrypt it.
The amount of time it takes set up encryption depends on the machine type being used. For
information on machine types, see "Machine Types", Read This First.
4. Preventing Leakage of Information from Machines
98
To Next Page
Loading...
Need help?
General
