• “Machinemodel_faxinfo.csv”
• “Machinemodel_taginfo.csv”
“Machinemodel_addr.csv” will be used as the Address Book file.
The Address Book data is now stored in the computer.
6. Close the [Address Management Tool] dialog box, and then close SmartDeviceMonitor
for Admin.
This will be followed by a procedure for displaying the computer's Address Book file on the LAN
Fax screen.
Using the Address Book stored in the computer for LAN-Fax
1. On the [File] menu, click [Print...].
2. Select [LAN-Fax M14], and then click [Print].
The LAN-Fax dialog box appears.
3. In [Address Book], click [Browse...].
4. Select the Address Book file, and then click [Open].
Select “Machinemodel_addr.csv”.
The Address Book appears.
5. Specify the destination.
For details about sending the file, see “Sending Fax Documents from Computers”.
• p.299 "Sending Fax Documents from Computers"
LAN-Fax Operation Messages
This section explains typical operation error messages displayed on the computer when using the LAN-
Fax Driver, and solutions to those messages.
Message
Causes and Solutions
The number of entries in Destinations exceed
the limits. Up to 500 entries can be entered.
The number of destinations specified exceeds the
maximum possible. The maximum number of
destinations that can be specified at one time is 500.
“LAN-Fax” has already been launched.
Cannot launch it again.
The [LAN-Fax] dialog box is already open. Quit
LAN-Fax once, and then start it up again.
6. Fax via Computer
324
To Next Page
Loading...
Need help?
General
