Ricoh SP 5200S User Manual

Reception Settings
This section describes the user tools in the Reception Settings menu under Facsimile Features.
Switch Reception Mode
Specify the method for receiving fax documents.
Default: [Auto Reception]
1. Press [Facsimile Features].
2. Press [Reception Settings].
3. Press [Switch Reception Mode].
4. Select the reception mode, and then press [OK].
To cancel the selection, press [Cancel].
5. Press the [User Tools/Counter] key.
For details about reception mode, see “Reception Modes”.
Program Special Sender
By programming particular receivers as Special Sender in advance, you can have Special Senders
treated differently.
For details about how to program Special Sender, see “Special Senders to Treat Differently”.
Program Special Sender: Print List
You can print the Special Sender List.
1. Press [Facsimile Features].
2. Press [Reception Settings].
3. Press [Program Special Sender: Print List].
4. Press the [Start] key.
To cancel printing a list before pressing the [Start] key, press [Cancel].
To cancel printing a list after pressing the [Start] key, press [Stop Printing].
5. Press the [User Tools/Counter] key.
Forwarding
Specify whether or not received fax documents are to be forwarded to a programmed receiver.
Default: [Off]
For details about Forwarding, see “Forwarding”.
Reception File Setting
Select whether received documents are saved on the hard disk to be printed later or printed
immediately without being saved.
Default: [Print]
7. Facsimile Features
342
7

Ricoh SP 5200S Specifications

General

Brand	Ricoh
Model	SP 5200S
Category	All in One Printer
Language	English