Ricoh SP 5200S User Manual

Acceptable Original Sizes
This section describes the size and thickness limitations that apply to originals placed on the exposure
glass or the ADF.
Original sizes and thickness
Where original
is set
Acceptable original size Maximum number of sheets Paper thickness
Exposure glass Up to A4 (210 × 297 mm),
8
1
/
2
× 11 (216 × 279 mm)
1 sheet
ADF, one-sided
original
A5 to A4
(up to 1,200 mm long)
5
1
/
2
× 8
1
/
2
to 8
1
/
2
×
14
50 sheets: Less than 80 g/
m
2
(21 lb. Bond)
*1
52 128 g/m
2
(14 34 lb.
Bond)
ADF, two-sided
original
A5 to A4
(up to 356 mm long)
5
1
/
2
× 8
1
/
2
to 8
1
/
2
×
14
50 sheets: Less than 80 g/
m
2
(21 lb. Bond)
*1
60 105 g/m
2
(16 28 lb.
Bond)
*1
Above specification depends on the paper type and condition
• You can use documents longer than 356 mm (14 inches) with the User Parameter (switch 14, bit 1)
in the Parameter Settings. For details about Parameter Setting, see “Parameter Settings”.
• p.375 "Parameter Settings"
Paper Size and Scanned Area
This section explains the size of the area the machine can scan.
• There may be a difference in the size of the image when it is printed at the destination.
• Even if an original is correctly placed on the exposure glass or in the ADF, a margin of 3 mm (0.1
inches) around each edge of the original may not be sent.
Placing Originals
61
1

Ricoh SP 5200S Specifications

General

Brand	Ricoh
Model	SP 5200S
Category	All in One Printer
Language	English