Detecting Blank Sheet
Upon completion of the first page scanning, an alarm sounds if the page is nearly blank.
• The blank sheet-detecting function works only when an original is scanned using the ADF.
• The blank sheet-detecting function is ineffective for second and subsequent pages.
• The machine cannot detect blank sheets if the user has put it into Preview mode using [Preview].
This function notifies you if an original is placed wrong side down on the scanner. When this happens, a
message appears for a few seconds. The message differs depending on number of pages to be scanned
and transmission mode.
• When sending a document using Immediate Transmission or when all pages have been scanned in
Memory Transmission:
• When some pages are left unscanned in Parallel Memory Transmission or Memory Transmission:
• Even if a near blank sheet is detected, it is transmitted as normal.
• You can turn this function on or off with the User Parameter (switch 11, bit 2). See “Parameter
Settings”.
• To cancel scanning if a blank sheet is detected, press the [Clear/Stop] key.
• p.375 "Parameter Settings"
Placing Originals
65
To Next Page
Loading...
Need help?
General
