237
Swirl Settings
You can set the amount of swirl, the swirl region, the
amount of rotation, and the swirl center position.
Applying the Swirl effect
In the Non Linear >Swirl menu (4141.26), set the
following parameters.
To turn the tip of the swirl into stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
To set the center position of the swirl
1
Press [Position].
2
Set the following parameters.
Melt Settings
You can set the degree of transition, the degree of
extension in the image, the jaggedness of the melting
sections, the amplitude and frequency, amount of
movement, the speed of the melting sections, the slant of
the borders, the shape of the sections that begin to melt,
and other parameters.
Applying the Melt effect
1
In the <Direction> group of the Non Linear >Melt
menu (4141.27), select the melt method.
Up: Melting occurs upward.
Down: Melting occurs downward.
2
To make transition settings, press [Transition] and set
the following parameters.
3
To make wave settings for the melting part, press
[Border] and set the following parameters.
a) Set when [Lock] is enabled.
b) Set when [Lock] is disabled.
To stop the wave in the melting part
Press [Lock], turning it on.
The wave alternately stops and starts each time the button
is pressed.
To select the shape of the part that starts to melt
1
Press [Form].
2
Set the following parameter.
a) 1 (SINE): Sine wave
2 (PARABOLA): Parabolic wave
3 (TRIANGLE): Triangular wave
4 (RECTANGLE): Rectangular wave
5 (CIRCLE): Circular wave
6 (CUBIC): Cubic curve wave
7 (MELT1): Melt waveform 1
8 (MELT2): Melt waveform 2
To turn the melting part into stardust
1
Press [Pixel], turning it on.
No. Parameter Adjustment
1 H Center point in horizontal direction
2 V Center point in vertical direction
No. Parameter Adjustment
1 Transition Swirl amount
2 Center Amount of rotation in center of swirl
3 Outer Amount of rotation outside of Area
4 Area Region of swirl
No. Parameter Adjustment
1 Density Degree to which image disappears
2 Random Trail type and amount of stardust
No. Parameter Adjustment
1 H Horizontal center position of swirl
2 V Vertical center position of swirl
No. Parameter Adjustment
1 Transition Degree of transition
2 Curve Degree to which image stretches
3 Random Degree of jaggedness at melted
part
No. Parameter Adjustment
1 Amp Amplitude of wave
2 Freq Frequency of wave
3 Offset
a)
Wave phase shift offset
4 Speed
b)
Direction of travel and speed of
wave
5 Slant Slant of border
No. Parameter Adjustment
1 Form Type of waveform
a)
To Next Page
Loading...
Need help?
General
