Sony XVS Series User Manual

21
4M/E configuration example using 36-button modules for cross-point control block and AUX bus
control block
M/E configuration example using transition control block (simple type)
Cross-Point Control Block
The cross-point control block is used to select the signals
to be used in the M/E banks and PGM/PST bank.
To use as a cross-point control block, the control panel
target row must be set to an M/E row or P/P row in the
Engineering Setup >Panel >Config menu (7321).
For details, see “Setting the Configuration for Each
Bank” (page 372).
M/E-1 bank
M/E-2 bank
M/E-3 bank
PGM/PST (program/preset) bank
Cross-point control block (page 21)
AUX bus control block
(page 43)
Flexi Pad control block (page 31)
Numeric keypad control block (page 40)
Key control block (page 33)
Device control block
(page 37)
Menu panel (page 47)
Transition control block (page 26)
Utility/shotbox control
block (page 42)
Independent key transition control block (page 30)
Transition control block (simple type) (page 29) Key fader control block
(page 36)
Note

Sony XVS Series Specifications

General

Brand	Sony
Model	XVS Series
Category	Switch
Language	English