242
Motion Decay Settings
Enabling Motion Decay automatically disables Trail,
Keyframe Strobe, or Wind if it is set.
Blurring image motion
1
Open the DME >Light/Trail >Motion Decay menu
(4153).
2
Press [Motion Decay], turning it on.
3
Set the following parameter.
a) 0.00 represents no afterimage. 100.00 represents no decay in the
afterimage.
4
In the <Decay Mix Mode> group, select the way in
which the video signal is blurred.
Soft: Mix the live image and the afterimage.
Hard: Show the brighter parts of the live image and
afterimage.
Erasing the afterimages that remain in
memory whenever a keyframe is passed
In the DME >Light/Trail >Motion Decay menu (4153),
press [Decay Eraser], turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
Selecting the freeze timing
In the <Decay Freeze Timing> group of the DME >Light/
Trail >Motion Decay menu (4153), select the timing for
freezing motion decay.
Frame: Freeze in frame units.
Field: Freeze in field units.
The freeze timing setting is not required when the
following signal formats are being used.
1080P/50, 1080P/59.94, 1080PsF/23.98, 1080PsF/24,
1080PsF/25, 1080PsF/29.97, 720P/50, 720P/59.94
To turn the afterimage portion into stardust
The afterimage portion becomes stardust, and gradually
disappears.
1
In the DME >Light/Trail >Motion Decay menu
(4153), press [Dust], turning it on.
2
Set the following parameters.
a) The way in which the afterimage disappears is affected by both the
motion decay Video Decay and Decay Dust parameter adjustments.
Keyframe Strobe Settings
Enabling keyframe strobe automatically disables Trail,
Motion Decay, or Wind if it is set.
Leaving a trail of afterimages
1
Open the DME >Light/Trail >KF Strobe menu (4154).
2
Press [KF Strobe], turning it on.
3
Set the following parameter.
a) 0.00 represents no afterimage. 100.00 represents no decay in the
afterimage.
Selecting the overlay priority for movie and
still images (video freeze image)
In the <Priority> group of the DME >Light/Trail >KF
Strobe menu (4154), select the way in which the images
are overlaid.
Over: The movie is on top, and the still image is
underneath.
Under: The movie is underneath, and the still image is on
top.
Mix: The movie and still images are mixed. You can set
the following parameter.
a) The 0.00 setting is the same as Over. 100.00 is the same as Under.
Note
No. Parameter Adjustment
1Video
Decay
Degree of decay of the video signal
a)
Note
No. Parameter Adjustment
1 Decay Dust Amount of the afterimage
disappearing as stardust
a)
2 Dust Soft Timing with which stardust
disappears
3 Dust Size Size of stardust
4 Dust Aspect Aspect ratio of stardust
Note
No. Parameter Adjustment
1 Decay Degree of decay of the video signal
a)
No. Parameter Adjustment
1 Mix Mix amount of the still image with
respect to the movie
a)
To Next Page
Loading...
Need help?
General
