Sony XVS Series User Manual

89
type from the current video to the new video. Moving the
fader lever from one end of its travel to the other completes
the transition.
To execute a manual transition with the transition control
block fader lever, use the following procedure.
To execute the transition completely
Move the lever over the full range of its travel.
To pause a partly executed transition
Stop moving the fader lever.
To resume a paused transition
Resume moving the fader lever.
Auto/Manual Transition Combination
Using the [AUTO TRANS] button, the [CUT] button, and
the fader lever, use the following procedures.
Moving the fader lever during an auto
transition
During an auto transition started by pressing the [AUTO
TRANS] button, operating the fader lever immediately
enables the fader lever, and the [AUTO TRANS] button
turns off. Thereafter, the fader lever controls the execution
of the transition.
Executing an auto transition after stopping
the fader lever mid execution
Press the [CUT] button to instantaneously complete the
transition.
Press the [AUTO TRANS] button to complete the
execution of the rest of the transition at the preset transition
rate. For example, if the transition rate is set to 100 frames,
and the fader lever has moved through
1
/
4
of the transition,
then the remaining
3
/
4
of the transition is executed in 100
frames.
Non-Sync State
If the fader lever is in an intermediate position when a
transition is completed as an auto transition, then the lever
position no longer agrees with the transition state. This is
termed non-sync state.
In non-sync state, the position from which a normal sync-
state fader lever transition can be resumed is indicated by
which of the two transition indicator LEDs (top, bottom, or
both ends) are lit or flashing.
• Moving the fader lever toward the position of the lit/
flashing LEDs does not execute a transition, but when
the fader lever reaches the end position the non-sync
state is released, and it is then possible to execute a
transition.
• If the fader lever is moved in the direction away from the
lit/flashing LEDs, the transition is executed over the
remaining part of the fader lever travel.
• Even in a non-sync state, you can execute an auto
transition. During auto transition execution by pressing
the [AUTO TRANS] button (or [TAKE] button), the
transition indicator shows the transition progress in the
usual way, but when the transition completes, they once
again indicate the non-sync state.
The transition indicator display state (lit or flashing) is set
in the Setup menu (see page 394).
Note
If an auto transition is executed
after moving the fader lever from
bottom to top and stopping mid
transition: Bottom two LEDs
light/flash.
Once the fader lever is
moved to this position,
the non-sync state
ends, and transition
execution is possible.
If an auto transition is executed
after moving the fader lever from
top to bottom and stopping mid
transition:
Top two LEDs light/flash.

Sony XVS Series Specifications

General

Brand	Sony
Model	XVS Series
Category	Switch
Language	English