226
The freeze timing setting is not required when the
following signal formats are being used.
1080P/50, 1080P/59.94, 1080PsF/23.98, 1080PsF/24,
1080PsF/25, 1080PsF/29.97, 720P/50, 720P/59.94
3
In the <Freeze> group, press [Time Strobe], turning it
on.
4
Set the following parameters.
Freezing using Film
When the signal format is 720P or 1080P, Film mode
cannot be selected.
1
Open the DME >Freeze >Freeze menu (4131).
2
In the <Freeze> group, press [Film], turning it on.
3
Set the following parameter.
Applying Special Effects
(Nonlinear Effect
Settings)
You can add a variety of effects that change the shape of
the image as a whole as nonlinear effects.
Non-Linear effect setting menu
1
Open the DME >Non Linear/Corner Pin >Non Linear
menu (4141).
2
Press a button for the desired effect to select it and
open the setting menu.
3
Configure settings for the selected effect.
• It is not possible to apply two or more nonlinear effects
at the same time. Enabling an effect automatically
disables the previously enabled effect.
• The Flex Shadow function cannot be enabled when the
Page Turn, Roll, Cylinder, or Sphere nonlinear effect is
enabled.
To disable an effect
Press the button for the effect name, turning it off, in the
corresponding effect setting menu.
Or, in the Non Linear menu (4141), press [OFF] in the
lower right of the display.
Wave Settings
There are two modes: H&V and Size. You can set the size
and frequency of the waves, the waveform, the amount of
wave movement, and the range. In H&V mode, you can
also set the wave angle.
Applying the Wave effect
1
In the <Mode> group of the Non Linear >Wave menu
(4141.1), select the wave modulation mode.
H&V: Modulate vertically and horizontally without
changing the size of the image. This mode allows
waves to be created in both the vertical and
horizontal directions at the same time.
Size: Create waves by reducing and expanding the
image. This mode allows waves to be created in
one direction only.
Note
No. Parameter Adjustment
1 Duration Freeze interval
2 Live Proportion of time between frozen
images for inserting live video
Note
No. Parameter Adjustment
1 Film Rate of film frame advance
Notes
To Next Page
Loading...
Need help?
General
