229
Applying the Twist effect
In the Non Linear >Twist menu (4141.4), set the following
parameters.
a) Set when [Lock] is enabled.
b) Set when [Lock] is disabled.
To stop the wave
Press [Lock], turning it on.
The wave alternately stops and starts each time the button
is pressed.
To select the waveform
Press [Form] and set the following parameters.
a) 1 (SINE): Sine wave
2 (PARABOLA): Parabolic wave
3 (TRIANGLE): Triangular wave
4 (RECTANGLE): Rectangular wave
5 (CIRCLE): Circular wave
6 (CUBIC): Cubic curve wave
Ripple Settings
There are four modes: Radial, Angular, Both, and Shape.
The direction of modulation differs depending on the
mode. You can set the size and frequency of the ripples,
their direction and speed, their center point, and other
parameters. In Shape mode, you can select ripple shapes
other than circles (stars, etc.).
Applying the Ripple effect
1
In the <Mode> group of the Non Linear >Ripple menu
(4141.5), select the ripple modulation mode.
Radial: Points on radii of the same length from the
center of the ripples behave in the same way.
Angular: Points at the same angle from the center of
the ripples behave in the same way.
Both: Radial and Angular ripples are applied
simultaneously.
Shape: The ripples can have shapes such as stars or
hearts, in addition to circles.
2
Set the following parameters, according to the selected
modulation mode.
When [Radial] is selected
When [Angular] is selected
Parameter group [1/2]
No. Parameter Adjustment
1 Amp V Amplitude of twist in vertical direction
2 Freq V Frequency of twist in vertical direction
3 Offset V
a)
Phase shift offset of twist in vertical
direction
4 Speed V
b)
Speed and direction of twist movement
in vertical direction
5 Slant Slant of twist
Parameter group [2/2]
No. Parameter Adjustment
1 Amp H Amplitude of twist in horizontal direction
3 Offset H
a)
Phase shift offset of twist in horizontal
direction
5 Slant Slant of twist
No. Parameter Adjustment
1 Form H Type of waveform in horizontal direction
a)
2 Form V Type of waveform in vertical direction
a)
No. Parameter Adjustment
1 Amp R Amplitude of ripple along radius
2 Freq R Frequency of ripple along radius
3 Offset R
a)
Phase shift direction and offset of
ripple along radius
4 Speed R
b)
Direction of travel and speed of
ripple along radius
5 Amp A Amplitude of ripple along
circumference
No. Parameter Adjustment
1 Amp A Amplitude of ripple along
circumference
Modulation along radii (Radial mode)
Modulation along circumference (Angular mode)