412
Settings Relating to Video
Switching
Selecting the Bank to Configure
In the Engineering Setup >Switcher >Transition menu
(7334), select the target bank to set and then configure the
bank.
Setting the transition preview mode
In the <Transition Preview> group of the Engineering
Setup >Switcher >Transition menu (7334), select one of
the following.
One Time: The transition preview ends after a single
transition ends.
Normal: Pressing the [TRANS PVW] button switches
between transition preview mode and normal mode.
Selecting independent key transition mode
In the <Key Transition> group of the Engineering Setup
>Switcher >Transition menu (7334), select one of the
following.
Same: The transition settings for key insertion and key
removal are common.
Independ: The transition settings for key insertion and
key removal are configured separately.
Selecting the background transition flip-
flop mode
In the Engineering Setup >Switcher >Transition menu
(7334), press [Bus Toggle] to enable (On) or disable (Off)
flip-flop mode.
On: Flip-flop mode
Off: Bus fixed mode
For details, see “Flip-flop mode and bus fixed mode”
(page 90).
Enabling/disabling split faders
In the Engineering Setup >Switcher >Transition menu
(7334), press [Split Fader] to enable or disable.
Enabling/disabling the fade-to-black
function
In the <FTB> group of the Engineering Setup >Switcher
>Transition menu (7334), select the program output.
To enable fade to black, press [PGM1] to [PGM4], turning
them on.
The PGM2 to PGM4 settings are enabled in multi program
mode or DSK mode only.
Setting a preset color mix
1
In the Engineering Setup >Switcher >Transition menu
(7334), press [Preset Color Mix].
The Preset Color Mix menu (7334.1) appears.
2
In the <Stroke Mode> group, select a stroke mode.
Normal: Carry out a preset color mix with two
transition operations.
Single: Carry out a preset color mix with a single
transition operation.
In bus fixed mode, the setting is fixed to [Single].
3
In the <Non Drop Key> group, select the key state for
a transition including a key.
To execute a transition with the key state maintained,
press [Key1] to [Key8], turning them on.
4
To return to the previous transition type setting each
time a transition ends, press [One Time Enable],
turning it on.
Setting fader lever operations
This sets the relationship between the fader lever position
and the progress state of the transition when executing a
transition.
1
In the Engineering Setup >Switcher >Transition menu
(7334), press [Transition Curve].
The Transition Curve menu (7334.2) appears.
2
In the <Fader Curve> group, select the fader lever
operation mode.
Normal: The transition progress is linear, according to
the fader lever position (factory default mode).
Adv Tally Mode: When the fader lever is moved from
the end of its travel, the tally is output slightly
before the transition starts.
No. Parameter Adjustment
1 Bank Switcher target bank selection
Note
Note
To Next Page
Loading...
Need help?
General
