92
2
Execute the transition.
Operate the fader lever, or press the [AUTO TRANS]
button or [CUT] button.
On the preview monitor, you can check the effect of
the transition.
Independent Key
Transitions
Overview
In addition to common transitions, it is possible to
configure independent transitions on the keyers of the M/
E banks and PGM/PST bank. These are called
“independent key transitions.”
By carrying out an independent key transition in
combination with a common transition, different transition
types can be used for the background and keys.
If the independent key transition mode is set to [Independ]
in the Setup menu, you can switch to a different transition
type and transition rate when the key is inserted or
removed.
For details about independent key transition mode
settings, see “Selecting independent key transition mode”
(page 412).
Combining transitions with independent
key transitions
When you set a common transition and a key independent
transition for the same key, you can apply two different
effects, such as a wipe and mix, simultaneously.
When executing such a combination of transitions on the
same key as an auto transition, the transition effect varies
depending on the timing at which the two transition and
independent key transition [AUTO TRANS] buttons are
pressed.
Transition type: wipe
Different wipe patterns are applied to the
background and key transitions.
Independent key transition
type: wipe
To Next Page
Loading...
Need help?
General
