405
Setting the format converter conversion
method
You can convert a 1080i input signal to a 3840×2160P
(Level A) signal.
Set the following items as the conversion method.
• Enhancer
• Conversion mode
1
In the Engineering Setup >Switcher >Input >Internal
FC menu (7332.5), press [FC Adjust].
The FC Adjust menu (7332.2) appears.
2
Display the target FC channels to set in the status area.
Press [FC 1-4], [FC 5-8], [FC 9-11], or [FC 13-16] to
switch the display in the status area.
3
Set the conversion method.
To configure the enhancer
1
Press [Enhancer], turning it on.
2
Set the following parameters.
a) 0 (high frequency) to 2 (low frequency)
To set the conversion mode
In the <Conversion> group, select the conversion mode.
Frame: Conversion in frame units
Field: Conversion in field units
Adaptive Y: Detects motion in the luminance signal, and
automatically switches between conversion using
frame units and field units.
Adaptive Y/C: Detects motion in the luminance and hue
signals, and automatically switches between
conversion using frame units and field units.
When [Adaptive Y] or [Adaptive Y/C] is selected, set the
following parameter.
a) 1: Mode with highest proportion converted from frames (still picture
priority mode)
2: Mode with higher proportion converted from frames
3: Mode with higher proportion converted from fields
4: Mode with highest proportion converted from fields (motion priority
mode)
To return the conversion method settings to the
defaults
Press [Default]. The settings for the selected FC channels
are reset to the defaults.
Setting the Active Area
For 4K signal inputs, the active area can be set to
3840×2160 or 4096×2160 for groups of four inputs.
[4096×2160] input signals can be selected only on AUX
bus outputs set to [4096×2160].
1
In the Engineering Setup >Switcher >Input menu
(7332), press [Active Area Size].
The Active Area Size menu (7332.4) appears.
2
Select the target input to set.
3
In the <Active Area Size> group, select the active area.
3840×2160: Set to 3840×2160.
4096×2160: Set to 4096×2160.
Parameter group [1/2]
No. Parameter Adjustment
2 Detail Gain Adjust the edge enhancement
sharpness
3 Limiter Adjust the maximum signal level
to be added to the original signal
4 Crisp Set the amplitude value for which
low-amplitude signals are not
enhanced
5Level
Depend
Set the luminance range for edge
enhancement
Parameter group [2/2]
No. Parameter Adjustment
2 Frequency Set the center frequency for edge
enhancement
a)
No. Parameter Adjustment
1Motion
Select
Motion detection sensitivity
a)
Note
To Next Page
Loading...
Need help?
General
