442 TMAA03-02 Security Bracket TM9100 Service Manual
© Tait Electronics Limited August 2005
17.5 Disassembling the Security Bracket
Disassemble the security bracket as follows:
1. Remove the radio from the security bracket by following the steps in
“Removing a Radio from the Security Bracket” on page 441.
2. Unscrew the four self-tapping screws holding the security bracket
base in place.
17.6 Ordering Extra Parts
The following parts can be ordered separately in case of loss, or in situations
where, for example, one security bracket is installed where several different
radios may be installed at different times.
Part Part Number Quantity
Security Crdl Key TM8
(slide lock key)
319-60004-XX 2
Security Crdl Mtg Short TM8
(short mounting rails for TM8100)
319-60002-XX 2
Scrw M4*25 T/T P/T ContiR
(for attaching short mounting rails to TM8100 radio)
349-02063-XX 4
Security Crdl Mtg Tall TM8
(tall mounting rails for TM8200)
319-60003-XX 2
Scrw M4*30 T/T P/T ContiR
(for attaching tall mounting rails to TM8200 radio)
349-02068-XX 4
To Next Page
Loading...
Need help?
General
