AA BB
Default, lower angle Raised, upper angle
To change the angle of the tray:
1. Move the top tray from the lower position AA, to the upper position BB.
2. Insert the tabs at the base of the tray into the upper position, BB.
Stacker Tray
The stacker tray has the following capabilities:
• Offset-capable for unstapled, single-staple, or multiple-staple sets
• Maximum capacity:
– PR Finisher: 3,000 sheets
– PR Finisher Plus and PR Booklet Maker Finisher: 2,000 sheets
Side stitch jobs are delivered to the stacker tray only.
Note: When 2000 or more sheets of paper with excessive downward curl are delivered to the output tray,
the output stack can fall from the tray. To correct the excessive downward curl of the paper, on the Interface
Decurler Module, set the curl-correction level to the lowest level. On the Inserter, change the curl-correction
setting to ddoowwnnwwaarrdd. For information, refer to Paper Curl Correction with the PR Finishers.
420
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide
Production Ready Finishers
To Next Page
Loading...
Need help?
General