Allen-Bradley E300 User Manual

Rockwell Automation Publication 193-UM015E-EN-P - October 2015 517
Metering and Diagnostics Chapter 8
L2 Reactive Power
L2 Reactive Power (Parameter 69) reports the reactive power for line 2 in kVAR
or MVAR depending on the configuration value for Power Scale (Parameter
377). When Voltage Mode (Parameter 352) is set to any Delta base setting, L2
Reactive Power is set to 0.
Table 483 - L2 Reactive Power (Parameter 69)
L3 Reactive Power
L3 Reactive Power (Parameter 70) reports the reactive power for line 3 in kVAR
or MVAR depending on the configuration value for Power Scale (Parameter
377). When Voltage Mode (Parameter 352) is set to any Delta base setting, L3
Reactive Power is set to 0. When Single or Three Phase (Parameter 176) is set to
Single Phase, L3 Reactive Power is set to 0.
Table 484 - L3 Reactive Power (Parameter 70)
Total Reactive Power
Total Reactive Power (Parameter 71) reports the total Reactive power of the
monitored power conductors in kVAR or MVAR depending on the
configuration value for Power Scale (Parameter 377). When Single or Three
Phase (Parameter 176) is set to Three Phase, Total Reactive Power is calculated as
follows:
Total Reactive Power = (L1 Reactive Power + L2 Reactive Power + L3 Reactive
Power)
When Single or Three Phase (Parameter 176) is set to Single Phase, Total
Reactive Power is calculated as follows:
Default Value 0.000
Minimum Value -2000000.000
Maximum Value 2000000.000
Parameter Type DINT
Size (Bytes) 4
Scaling Factor 1000
Units kVAR or MVAR
Default Value 0.000
Minimum Value -2000000.000
Maximum Value 2000000.000
Parameter Type DINT
Size (Bytes) 4
Scaling Factor 1000
Units kVAR or MVAR

Allen-Bradley E300 Specifications

General

Brand	Allen-Bradley
Model	E300
Category	Other
Language	English