Barco DP2K SLP Series Service Manual

R5906848 /04 DP2K SLP Series344
Situation Solution
Damaged wire. Remove the projector top cover and top cover plate. Look inside the
compartment above the Card Cage to check the wire of the ICP fan.
Repair if possible, otherwise replace with new one. See service manual
chapter “Replacement of the ICP fan”, page 222.
Malfunction Cinema Control
board.
Replace the Cinema Control board. See service manual chapter
“Replacement of the Cinema Controller”, page 217.
Fan end of life. Replace the ICP fan. See service manual chapter “Replacement of the
ICP fan”, page 222.
1
11
Image 25-87
Code 6200: “maintenance - maintenance required” (Notification)
Situation Solution
Projector requires
maintenance.
Go to the menu “Maintenance → Smart maintenance” in the
Communicator software.
See also maintenance program of the projector (included in the service
manual).
Code 6210: “lens - no lens parameter file has been activated” (Warning)
Situation Solution
No lens parameter file has
been activated.
Select a suitable lens parameter file for the installed lens using the
Communicator software.
>Installation >Advanced >Lens parameters >Select
Code 6233: “light pipe fan - speed low” (Warning)
Situation Solution
Blocked fan. Unblock the fan. Ensure that the fan can turn freely (reference 2Image 25-
88).
Damaged wire. Check the wire (reference 1Image 25-89) of the fan. Repair if possible,
otherwise replace with new one. See service manual chapter
“Replacement of the Light Pipe fan”, page 136.
Fan end of life. Replace the fan. See service manual chapter “Replacement of the Light
Pipe fan”, page 136.
Malfunction Cinema Control
board.
Replace the Cinema Control board. See service manual chapter
“Replacement of the Cinema Controller”, page 217.
Troubleshooting

Barco DP2K SLP Series Specifications

General

Brand	Barco
Model	DP2K SLP Series
Category	Projector
Language	English