00.13
Renewing fuel filter
Inspection III
•
If necessary, reduce fuel level with pump until fil-
ter is clear.
•
Loosen hose clip (1) and shift towards filter.
•
Detach line and remove filter together with line
from the fuel tank.
•
Change fuel filter.
L Note:
Note direction of fuel flow on filter.
•
Reconnect line to pump.
•
Install in the reverse order of removal.
L Note:
Gasket (2) must not close off the overflow hole. En-
sure recesses (arrows) in gasket are fitted in correct
position.
Cleaning inductive pulse generator
at rear wheel drive
Inspections I, III, IV
•
Release securing screw (1).
•
If necessary lever out inductive pulse generator
and clean with rag.
X Tightening torque:
Inductive pulse generator at rear wheel....... 2.5 Nm
LT000070
1
2
LT000080
1
To Next Page
Loading...
Need help?
General
