34.25
Removing and installing rear ABS
sensor
•
Remove brake caliper but do not loosen brake
line.
•
Release sensor with socket wrench,
BMW No. 00 2 640.
•
Disconnect plug connection (1) for sensor line.
•
Install in the reverse order of removal.
e Caution:
Check sensor spacing where the gap is greatest; if
necessary, adjust with spacer plates (3).
Carefully lay sensor line.
Sensor gap
Up to 1996 model year..................0.60 ... 0,65 mm
................................................ (0.0236...0.0256 in)
From 1997 model year on ............0.45 ... 0.55 mm
................................................ (0.0177...0.0216 in)
X Tightening torque:
Sensor .......................................................... 4 Nm
LT340160
2
1
To Next Page
Loading...
Need help?
General
