34.8
Removing and installing brake pads
•
Remove brake caliper.
L Note:
If only the brake pads are to be replaced, do not re
lease the brake line at the brake caliper.
•
Drive out retaining pin (1).
•
Remove brake pads by pulling downwards.
e Caution:
Do not allow brake pads to wear down below the
minimum thickness (arrow).
Replace pads only as complete set.
Minimum brake pad thickness:
Thickness on carrier plate ...........................1.5 mm
•
Install in the reverse order of removal.
L Note:
Before installing the brake pad, completely press
back the pistons with the aid of the resetting tool (1),
BMW No. 34 1 500.
LT340030
1
LT340040
1
To Next Page
Loading...
Need help?
General
