46.27
Checking switching function of side
stand
•
Set vehicle on centre stand on even base or lift-
ing platform.
•
Spray switching kinematics of side stand with
quick-action cleaner and fold out and in several
times.
•
Completely fold out side stand and mark position
on the base.
•
Make a second marking at the distance ”a” and
a third marking at the distance ”b”.
Distances:
”a” .................................................. 95 mm (3.74 in)
”b”.................................................. 50 mm (1.97 in)
•
Fold in side stand and start engine.
•
Slowly fold out side stand, the engine must cut
out in the area of dimension ”b”.
•
If the engine does not cut out, check or replace
the switch.
e Caution:
Bending the contact spring can cause switch mal-
functions.
Therefore:
Never bend the contact spring!
•
Operate starter while slowly folding in side stand,
the engine must start up in area ”b”.
•
If the engine does not start up, or if the side stand
is difficult to move, check the switch or disas-
semble the side stand.
LT460380
a
b
To Next Page
Loading...
Need help?
General
