Cisco ASR 1000 Series Software Configuration Guide

CHAPTER 10
Configuring the Ethernet SPAs
This chapter provides information about configuring the Fast Ethernet and Gigabit Ethernet SPAs on the
Cisco ASR 1000 Series Routers.
•
Configuration Tasks, page 117
•
Verifying the Interface Configuration, page 133
•
Using show Commands to Check SFP Module and XFP Module Status, page 133
•
Configuring LAN/WAN-PHY Controllers, page 147
•
Configuration Examples, page 169
Configuration Tasks
This section describes how to configure the Gigabit Ethernet and Fast Ethernet SPAs and verify the
configuration. For information about managing your system images and configuration files, refer to the
following:
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
•
Cisco IOS Configuration Fundamentals Configuration Guide
•
Cisco IOS Configuration Fundamentals Command Reference
Required Configuration Tasks
This section lists the required configuration steps to configure the Gigabit Ethernet SPAs. Some of the required
configuration commands implement default values that might be appropriate for your network. If the default
value is correct for your network, then you do not need to configure the command. These commands are
indicated by “(As Required)” in the Purpose column.
To configure the Fast Ethernet or Gigabit Ethernet SPAs, complete the following steps:
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 117

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English