Cisco ASR 1000 Series Software Configuration Guide

Framing is M13, Line Code is B3ZS, Clock Source is Line
Equipment customer loopback
Data in current interval (656 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
666 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
0 Severely Errored Line Secs
0 Far-End Errored Secs, 0 Far-End Severely Errored Secs
0 CP-bit Far-end Unavailable Secs
0 Near-end path failures, 0 Far-end path failures
0 Far-end code violations, 0 FERF Defect Secs
0 AIS Defect Secs, 666 LOS Defect Secs
Configuring FDL
Facility Data Link (FDL) is a far-end performance reporting tool. In ANSI mode, you can enable one-second
transmissions of performance reports on both ends of the T1 connection. To configure FDL, use the following
commands:
PurposeCommand
Enters global configuration mode.Router# configure terminal
Selects the controller to configure and enters interface
configuration mode.
Router(config)# controller t3 slot/subslot/port
(Optional) Enables FDL.
• number—Specifies the T1 channel number.
• ansi—Specifies the FDL bit per the ANSI
T1.403 specification.
Router(config-controller)# t1 number fdl {ansi}
Verifying FDL
Use the show controller command to display the FDL setting:
Router# show controller t3 3/0/1/1
T3 3/0/1 is down. Hardware is 2 ports CT3 SPA
ATLAS FPGA version: 0, FREEDM336 version: 0
TEMUX84(1) version: 0, TEMUX84(1) version: 0
SUBRATE FPGA version: 0
Applique type is Channelized T3
Receiver has loss of signal.
Framing is M23, Line Code is B3ZS, Clock Source is Internal
Equipment customer loopback
Data in current interval (456 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
456 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
0 Severely Errored Line Secs
0 Far-End Errored Secs, 0 Far-End Severely Errored Secs
0 CP-bit Far-end Unavailable Secs
0 Near-end path failures, 0 Far-end path failures
0 Far-end code violations, 0 FERF Defect Secs
0 AIS Defect Secs, 456 LOS Defect Secs
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
248 OL-14127-17
Configuring the 2-Port and 4-Port Channelized T3 SPAs
Optional Configurations

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English