Listing the Available Cisco WebEx SPA Console Commands
The Cisco WebEx SPA console supports a similar help function as the RP console. You can enter ? at the
console to obtain a list of the available commands as shown in the following example:
service-spa# ?
Exec commands:
clean Clean commands
copy Copy files from src to destination
delete Remove files
dir Directory listing for files
exit Exit from the EXEC
format Format a device with ext3/fat16/dummy file system
fsck Perform file system check operation
less Shows content of file
load Load plug-in image
mkdir Create new directory
move Move files
ping Send echo messages
rmdir Remove existing directory
show Show system information
terminal Set terminal line parameters
traceroute Trace route to destination
webex Webex Application Commands
Some of the most useful commands include:
• show eventlog—Dumps the content of the /var/log/messages file.
• show disk partitions—Displays the partitions available on the hard disk drive (HDD).
• show disk smart—Displays S.M.A.R.T. output of the HDD.
• show tech-support—Gathers information for troubleshooting.
• ping—Sends echo messages.
• copy tftp: disk0:—Copies files from a TFTP server to the HDD first partition.
• load—Loads a plug-in image.
• exit—Exits from the Cisco WebEx Node SPA console.
Exiting the Cisco WebEx Node SPA Console
To exit the SPA console, use the exit command as shown in the following example:
service-spa# exit
Router#
Handling TraceBack and Core Dump Files on the Cisco WebEx Node SPA
This section describes how to gather traceback and core dump file information for troubleshooting by Cisco
technical support.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 385
Troubleshooting the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
Handling TraceBack and Core Dump Files on the Cisco WebEx Node SPA
To Next Page
Loading...
Need help?
General
