Cisco ASR 1000 Series Software Configuration Guide

Deactivation of SIP is not supported on Cisco ASR 1001, Cisco ASR 1002 and Cisco ASR 1002-X routers.Note
Activation of a SIP Configuration
Activate a SIP if you have previously deactivated it. If you did not deactivate the SPAs, the SPAs automatically
reactivate with reactivation of the SIP.
The following example activates the SIP that is installed in slot 1 of the Cisco ASR 1000 Series Aggregation
Services Routers, its SPAs, and all of the interfaces (as long as the hw-module subslot shutdown command
was not issued to also deactivate the SPA):
Router(config)# hw-module slot 1 start
There are no corresponding console messages shown with activation using this command. If you re-enter the
hw-module slot start command, a message is displayed indicating that the module is already enabled.
Deactivation of a SPA Configuration
Deactivate a SPA when you want to perform OIR of that SPA. The following example deactivates the SPA
(and its interfaces) that is installed in subslot 0 of the SIP located in slot 1 of the Cisco ASR 1000 Series
Aggregation Services Routers and removes power to the SPA:
Router(config)# hw-module subslot 1/0 shutdown unpowered
Activation of a SPA Configuration Example
Activate a SPA if you have previously deactivated it. If you have not deactivated a SPA and its interfaces
during OIR of a SIP, then the SPA is automatically reactivated upon reactivation of the SIP.
The following example activates the SPA that is installed in subslot 0 of the SIP located in slot 1 of the Cisco
ASR 1000 Series Aggregation Services Routers:
Router(config)# no hw-module subslot 1/0 shutdown
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 45
Troubleshooting the SIP
Deactivation and Activation Configuration Examples

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English