PurposeCommand or Action
Example:
Router(config-dspfarm-profile)# codec
g723r53
Specifies the maximum number of sessions that are supported by
the profile.
maximum sessions number
Example:
Step 9
• number —Range is determined by the available registered
DSP resources. Default is 0.
Example:
Router(config-dspfarm-profile)# maximum
sessions 4
By default, the maximum sessions are counted from the
subslot where the SPA-DSP is available. If there are more
than one SPA-DSPs and the maximum sessions exceed
the session limit per SPA-DSP, the remaining sessions
are managed by the second SPA-DSP.
Note
Associates the SBC application to the DSP farm profile.associate application sbc
Example:
Router(config-dspfarm-profile)# associate
application sbc
Step 10
Enables the profile, allocates DSP farm resources, and associates
the application.
no shutdown
Example:
Router(config-dspfarm-profile)# no shutdown
Step 11
Exits DSP farm profile configuration mode.exit
Example:
Router(config-dspfarm-profile)# exit
Step 12
What to Do Next
For more information related to associating an SBC to a DSP farm profile, see the “Cisco Unified Border
Element (SP Edition) - SPA DSP Services” chapter in “Cisco Unified Border Element (SP Edition) Configuration
Guide: Unified Model”:
http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/sbcu/sbc_spadsp.html
For SBC configuration information (Call-admission-control [CAC] and DTMF internetworking) too, see the
Cisco Unified Border Element (SP Edition) Configuration Guide: Unified Model .
Enabling or Disabling Voice Activity Detection (VAD)
Execute the following steps to enable or disable local VAD settings irrespective of external VAD settings.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
410 OL-14127-17
Configuring the Cisco DSP SPA for the ASR 1000 Series Aggregation Services Routers
Enabling or Disabling Voice Activity Detection (VAD)
To Next Page
Loading...
Need help?
General
