Cisco ASR 1000 Series Software Configuration Guide

CommentCommand
Router(config-if)# ip ?
Interface IP configuration subcommands:
access-group Specify access control for
packets
accounting Enable IP accounting on this
interface
address Set the IP address of an
interface
authentication authentication subcommands
bandwidth-percent Set EIGRP bandwidth limit
broadcast-address Set the broadcast address of an
interface
cgmp Enable/disable CGMP
directed-broadcast Enable forwarding of directed
broadcasts
dvmrp DVMRP interface commands
hello-interval Configures IP-EIGRP hello
interval
helper-address Specify a destination address
for UDP broadcasts
hold-time Configures IP-EIGRP hold time
Router(config-if)# ip
Enter the command that you want to configure for the interface.
This example uses the ip command.
Enter ? to display what you must enter next on the command line.
This example shows only some of the available interface IP
configuration commands.
Enter the command that you want to configure for the interface.
This example uses the ip address command.
Enter ? to display what you must enter next on the command line.
In this example, you must enter an IP address or the negotiated
keyword.
A carriage return (<cr>) is not displayed; therefore, you must
enter additional keywords or arguments to complete the command.
Router(config-if)# ip address ?
A.B.C.D IP address
negotiated IP Address negotiated over PPP
Router(config-if)# ip address
Enter the keyword or argument that you want to use. This example
uses the 172.16.0.1 IP address.
Enter ? to display what you must enter next on the command line.
In this example, you must enter an IP subnet mask.
A <cr> is not displayed; therefore, you must enter additional
keywords or arguments to complete the command.
Router(config-if)# ip address 172.16.0.1 ?
A.B.C.D IP subnet mask
Router(config-if)# ip address 172.16.0.1
Enter the IP subnet mask. This example uses the 255.255.255.0
IP subnet mask.
Enter ? to display what you must enter next on the command line.
In this example, you can enter the secondary keyword, or you
can press Enter.
A <cr> is displayed; you can press Enter to complete the
command, or you can enter another keyword.
Router(config-if)# ip address 172.16.0.1 255.255.255.0
?
secondary Make this IP address a secondary
address
<cr>
Router(config-if)# ip address 172.16.0.1 255.255.255.0
In this example, Enter is pressed to complete the command.
Router(config-if)# ip address 172.16.0.1 255.255.255.0
Router(config-if)#
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 11
Using Cisco IOS XE Software
Finding Command Options: An Example

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English