Cisco ASR 1000 Series Software Configuration Guide

PurposeCommand or Action
• name-server1-ip-address—Specifies the IP address of the primary domain
name server.
• name-server2-ip-address—Specifies the IP address of the secondary
domain nameserver.
Specifies the host name and domain name given to the Cisco WebEx Node
SPA, where:
Router(config-if)# service-engine
hostname module-side-hostname
module-side-domain-name
Step 7
• module-side-hostname—Specifies the host name of the service engine
interface. The default host name is “service-spa.”
• module-side-domain-name—Specifies the domain name of the service
engine interface.
The domain name must be assigned as a preliminary step. See the
Registering with the WebEx Data Center and the Cisco WebEx Node
Management System, on page 353.
Note
Specifies the URL provided by registration and provisioning of the SPA in the
Cisco WebEx Node Management System.
Router(config-if)# service-engine
wma-url url-string
Step 8
For more information, see the Registering with the WebEx Data Center and the
Cisco WebEx Node Management System, on page 353.
Specifies the encrypted token string provided by the Cisco WebEx Node
Management System.
Router(config-if)# service-engine
wma-token token-string
Step 9
The token-string must match the code provisioned in the Cisco WebEx
Node Management System for the named SPA. For more information,
see the Registering with the WebEx Data Center and the Cisco WebEx
Node Management System, on page 353.
Note
Specifies the WebEx Node SPA name and key used for authentication, where:Router(config-if)# service-engine
wma-passcode name-string key-string
Step 10
• name-string—Specifies the name assigned to the SPA.
• key-string—Specifies the password used for encrypted authentication.
The key-string must match the passcode provisioned in the Cisco
WebEx Node Management System for the named SPA. For more
information, see the Registering with the WebEx Data Center and the
Cisco WebEx Node Management System, on page 353.
Note
Activates the interface.Router(config-if)# no shutdown
Step 11
What to Do Next
The following is an example of the use of these configurations:
ip nat inside source static 10.200.72.18 192.0.2.1
interface Service-Engine1/0/0
ip address 10.200.72.17 255.255.255.252
ip nat inside
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
360 OL-14127-17
Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
Configuring the Virtual Service Engine Interface

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English